If you are getting ready to start a factory renovation using EPS Cement Sandwich Panel, following a few simple practical installation tips will help you make the process go even faster, get a better final result, and avoid common small mistakes that can slow your project down. First, before any panels arrive on site, make sure your factory floor surface is completely level, clean and dry. Even small uneven spots on the floor can make it hard to get your first row of panels perfectly straight, which will cause alignment issues all the way up your wall. Taking the time to level the floor properly at the very start will save you hours of adjustment work later on. It is also a good idea to map out your full wall layout on the floor with clear marker lines before you start installing anything. Mark exactly where every panel will go, where all your door openings will be, and where any pipes or wiring will need to pass through the panels. This way, you can pre-cut all the necessary openings in the EPS Cement Sandwich Panel before you lift them into place, which is much easier than trying to cut them once the panel is already standing and secured. When you are moving the panels around your factory site, be careful not to drag them on the ground, as this can scratch or damage the smooth cement facing. Instead, carry them carefully with two people, or use a simple wheeled cart to move them, to keep the panel surface in perfect condition so you do not have to do extra repair work later. When joining two panels together, use the recommended specialized joint sealant that is designed for use with these panels. This will create a tight, seamless gap between panels that is completely airtight, water-resistant and helps maintain the full insulation performance of the entire wall. If you skip the proper sealant, you can end up with small hidden gaps that let air leak through, which will reduce the energy efficiency of your new wall. For any panels that need to have pipes or electrical wiring run through them, use a simple hole saw to make clean, neat openings, and then seal around the edges of the opening with a small amount of fire-resistant sealant. This keeps the fire resistance and sound insulation properties of the panel fully intact, even after you have cut through it. Finally, once all your panels are installed, do not wait too long to apply your final protective paint or industrial coating. The smooth surface of the EPS Cement Sandwich Panel takes paint extremely well, and adding a good quality industrial top coat will make the wall even more resistant to scuffs, spills and heavy industrial wear, keeping it looking great for many years. These simple tips will help your installation team work faster, avoid unnecessary errors, and get the absolute best performance out of every panel you install.
